.Slayer Exciter Home Page This is a Fully assembled Slayer Exciter. It acts as a high frequency  solid state Tesla Coil. Runs on DC from 1.5v to 12v or more, Great for Camping or Emergency Lighting,Light LED's and Florescent tubes wireless as low as 1.5 Volts.  This Slayer Exciter comes as pictured above with the coils Pre-Wound and the 1.5 volt   Exciter Pre-Made on the breadboard. All that is needed is to connect the coils to the  circuit and connect the battery.    This also comes with three Slayer Exciter circuits and extra components to make all the Slayer Exciter circuit versions including the high voltage 12 volts or more Slayer Exciter.    The extra components are. 1=High Quality RadioShack Breadboard with the1.5v Slayer Exciter on the Breadboard 1=100k resistor 1=1M resistor 1=led 1=500pf capacitor assorted test jumpers 3=2N2222 transistors 1=Tip31 transistor 1=Tip42c transistor 2=UF4007 diodes 2=1N4148 diodes 1=Heatsink 1=9 turn pancake coil 1=5 turn pancake coil 1=L2 coil, 1=L3 coil 1=AA battery holder 2=Clip leads 3=Circuit Diagrams SLAYER EXCITER DISCLAIMER (03/06/13) WARNING: You must be 18 years or older to purchase this product. If running at higher voltages this product can be a fire hazard. This product is for educational purposes only. It is not meant to replace any conventional lighting method. Do NOT use around any sensitive electronics, children or pets. Please be aware and follow any FCC regulations in your area. By purchasing this product YOU AGREE to this disclaimer AND TAKE FULL RESPONSIBILITY for any mishap that may happen when using this product this includes but is not limited to any health or property damages that may arise from using this product. THE SELLER DOES NOT ASSUME ANY RESPONSIBILITY OR LIABILITY FOR THIS PRODUCT. THIS PRODUCT IS SOLD "AS IS" WITH NO WARRANTY OR LIABILITIES. THE BUYER ASSUMES ALL RESPONSIBILITY FOR THIS PRODUCT'S USE. *PURCHASER AGREES TO HOLD SELLER "HARMLESS".*